#Instructions cateye enduro 8 install
#Instructions cateye enduro 8 manual

Test The Basic Functions Rotate the front wheel gently and see if the computer indicates the running speed. Setting is completed by pushing the SET button. Note You can easily set it by referring to the chart shown right. Set The Tire Circumference Set the tire circumference in cm. Note Allow enough wire clearance in the area marked with an to insure that you can turn the handlebar from left to right without pulling the wire. When you need to detach the computer, slide forward the computer with the lever pushed simultaneously. The contact points are automatically closed. Slide the computer into the bracket 1 until you hear the click sound.

Put the rubber pad 6 on the bracket 1 and secure the bracket on the handle bar with the screw. Mount The Bracket Secure the cord on the fork with the nylon ties 7 and lead to the handle bar along the outer cable of the bicycle by means of the spiral tube 8. Rotate the sensor on the front fork to adjust the gap between the sensor and the magnet 5 within 5 mm, and secure it with the nylon ties. Mount sensor and adjust the gap between the magnet and the sensor.

When you want to start the odometer from zero, push the START/STOP button.

When you want to input the reading of the currently used odometer, keep pressing the MODE button for two seconds and input the reading.

Select the measurement unit, kilometer or mile, by pushing the MODE button. Magnet Bracket Rubber Pad Five Nylon Ties Spiral Tubeĥ on a spoke of the front wheel so that the surface of the magnet will face the sensor. SET Buttonġ Bracket 2 Cord 3 Sensor 4 Sensor Rubber Pad * Do this procedure without fail for stable measurement when you use this system for the first time and every time the battery is replaced. Push three buttons (MODE, START/ STOP and SET) at the same time. Installation of the Computer on Your Bike The computer is combined with the following parts.

#Instructions cateye enduro 8 manual

Please don’t throw away this manual, Keep the manual at a place easily accessible. NoteĬomputer Set-up (For 1st use or after replacing the battery) Important Don’t use thinner, benzene or alcohol to wipe the surface of the computer.Never attempt to disassemble the computer head. Avoid unnecessary prolonged exposure to the sun.

#Instructions cateye enduro 8 install

Please read these instructions carefully before attempting to install and use your CAT EYE ENDURO 8 computer so that you understand the functions of this product. Dispose of batteries according to local regulations. Keep batteries out of reach of small children.Periodically check to insure they are mounted securely and the screws are not loosen. Be sure to securely mount the magnet, the sensor, and the bracket on your bicycle.Pay attention to the road or trail! Do not be distracted by the computer.